A leak in Dardanelle is often a spring event. The building has been empty since the gate closed, and the first visit of the season finds water where it has been standing for weeks.
Start with where the water is
At the top of the tank, the connections and unions. At the side, a T&P valve passing into its discharge pipe. At the base, the drain, an element gasket, or the shell itself. Along the floor, a split line that froze.
The last one is the local classic: a pipe above the heater that froze in January, split, and let go on the first warm day of spring.
Components that can be repaired
Fittings and unions, the drain valve, element gaskets, the relief valve and its piping. Those are leaks with a cause that ends when the part is replaced.
A tank leaking at a seam or through the shell is not in that category. No sealant or patch holds against a corroded tank, and a repair attempt is money that delays the replacement.
The relief valve question
A valve that discharges is doing its job — the question is why it was asked to. Over-pressure from a failed expansion tank, over-temperature from a thermostat, or a valve that no longer seats.
Swapping the valve without checking the cause is how the same leak comes back next season, when nobody is there to see it.
Damage beyond the heater
Months of slow water in a closed building does more than wet the floor: subfloor, insulation, framing, and in a crawlspace, the moisture that brings rot. Fixing the heater is the smaller half of a call like this.
Stopping it before the next closure
The prevention is a working shut-off at the heater, a pan with a discharge that goes somewhere safe, and a shutdown done by the label. Three things that cost little and are done at the one visit per year when anyone is there.