Skip to content

Strawberry, California

Water heater questions

Straight answers on repair versus replacement, permits, tankless units, well water, winter shutdowns and what to do before you call.

Most calls about a water heater come down to four decisions: what has failed, whether it can be repaired, whether the installation around it is safe, and whether the work needs a permit. The answers below cover the ones that come up most on this corridor.

Repair, replace or wait

A part failure on a sound tank is a repair. A leaking tank shell is not — once the steel is perforated, no repair holds. Between those two is the grey area where a unit has had several failures in a short period, or where the water has eaten the anode and started on the tank. That is where the condition of the tank, not the age on the label, decides.

Permits and inspections

Tuolumne County permits water heater replacement in the unincorporated area. The county enforces the 2025 California Building Standards Code and its water heater inspection standards name the things an inspector checks: seismic strapping, combustion air, the temperature and pressure relief valve and its drain, location and clearances, and vent termination and clearances. Repair and maintenance are not permitted work.

Tank or tankless

Tankless units save space and heat water on demand, but they ask more of the building: adequate gas or electrical capacity, a suitable vent, and water that will not scale the exchanger. On a corridor where much of the housing is seasonal and supplied by wells, those conditions are worth checking before a unit is chosen rather than after.

Water quality and maintenance

Sediment collects in a tank and coats elements; hardness scales a tankless exchanger. Flushing removes that material but does not undo damage already done. An anode rod is a sacrificial part and is meant to be consumed — checking it is cheaper than replacing a tank.

Gas safety

A gas smell is not a service call, it is an emergency: leave, then call the utility and 911. A blocked or snow-covered vent is also a safety problem, not just a performance one, because carbon monoxide has nowhere to go.

Before you call

Have the address, the fuel type, the tank or tankless distinction, and the symptom. If water is escaping, close the inlet valve and cut the power or gas. Everything else can be worked out on the call.

Get in touch

Still not sure what is wrong?

Describe the symptom on the phone and you will get the likely causes and the sensible next step.

Questions, answered

Should I repair or replace?

Repair when the fault is a part — a thermocouple, element, thermostat, valve or pilot assembly — and the tank is sound. Replace when the shell is leaking, the tank is rusting through, or the same part keeps failing. A leak from the tank itself cannot be repaired.

How long should a water heater last?

It depends on the water, the installation and how hard the unit works. Sediment, aggressive water, high inlet pressure and a missing expansion tank all shorten life. A unit that has had regular flushing and correct venting usually outlasts one that has not.

Does a replacement need a permit?

In unincorporated Tuolumne County, yes. Replacement is permitted work applied for through the county's online portal, and the installation is inspected for strapping, combustion air, relief-valve piping, clearances and venting. Repair and maintenance do not need one.

Why does my water heater run out of hot water faster than it used to?

Usually sediment has taken up space in the tank, a dip tube has failed, or a heating element or thermostat is weak. On a tankless unit, scale in the exchanger or a flow rate below the unit's minimum can produce the same complaint.

Is tankless worth it here?

It depends on the house. Tankless units need adequate gas or electrical capacity, a suitable vent, and water quality that will not scale the exchanger quickly. In a seasonal cabin with a small electrical service or hard well water, a tank is often the more practical choice, and that trade-off is worth discussing before buying anything.

My pilot will not stay lit. What is likely wrong?

Common causes are a failed thermocouple or flame sensor, a dirty pilot orifice, a draft or venting problem, or a gas supply issue. Each is tested rather than replaced by guesswork.

There is water on the floor. Is the tank finished?

Not always. Water can come from a failed relief valve, a loose fitting, an element gasket or a drain valve, and those are repairable. A leak from the tank shell itself is not. The source decides, which is why the first step is finding where the water is coming from.

Why does this happen more in winter?

Freezing, and vacancy. Pipes and heaters in unheated spaces see far colder conditions than the house does, and a leak in an empty cabin can run for weeks. Snow can also bury a vent termination, which is a safety issue on a gas unit.

Do you service commercial systems?

Yes. Commercial work often means larger storage, multiple units, recirculation or higher demand, and it may need a commercial permit rather than a residential one.

What should I do before you arrive?

Close the cold-water inlet valve and shut off the power or gas if water is escaping. If you smell gas, leave the building and call the gas utility and 911 first.

Call(989) 601-2666