Skip to content

Install

Water heater installation

Installing a new water heater in Strawberry and the Highway 108 corridor — sizing, fuel and electrical capacity, venting, location and the county permit.

Installation is the part of the job that decides how the next ten years go. A correctly sized unit with the right vent, the right clearances and a sound connection outlasts a larger unit installed badly, and on this corridor the building usually constrains the choice more than the catalogue does.

What the building allows first

Before a unit is chosen, three things in the building are checked.

Fuel capacity. A gas line sized for a storage heater may be too small for a tankless unit drawing far more at once, and upsizing a gas line is a separate job from installing a heater.

Electrical capacity. Electric tanks draw on a dedicated circuit; a tankless electric unit can need several. In older cabins the service panel is often the limiting factor.

Venting. A storage heater can use a conventional flue; a high-efficiency or tankless unit usually needs a different vent, and sometimes a different route through the roof. On a roof that carries a real snow load, where the vent terminates matters as much as what it is made of.

Sizing for how the house is used

Sizing is about peak demand, not floor area. The useful questions are how many people use hot water at once, whether there is a tub or a large shower, whether there is a dishwasher or laundry, and whether the property is occupied year-round or in bursts.

A seasonal cabin used by two people most of the year and by eight in August is a genuinely awkward case: size for the peak and the unit spends most of its life cycling, size for the average and August is cold. That trade-off is worth deciding deliberately.

Location and clearance

A heater needs a location that can carry it, drain around it and vent from it. Combustion air matters on a gas unit in a tight closet, and a closet that was adequate for an old unit is not automatically adequate for a new one. In this county, location, clearances and combustion air are inspection items, not preferences.

The permit and inspection

Installation in unincorporated Tuolumne County goes through the county's OpenGov portal under the 2025 California Building Standards Code. The county's water heater inspection standards name what is checked: seismic strapping, combustion air, the temperature and pressure relief valve and its drain, location and clearances, and vent termination and clearances.

Inspections are requested through the building inspection line before 3:00 p.m. the day before. Contractors must hold a current state licence.

What drives the price

The unit, the venting, whether the gas line or electrical service has to change, the location and the access. A straight swap of a like-for-like tank in an accessible garage is a different job from a tank-to-tankless conversion in a closet with a roof vent that has to be re-routed.

Water Heater Installation service areas

How coverage is decided

Get in touch

Planning a new water heater?

Call before you buy the unit. Capacity, venting and location decide whether it will work in the building.

Questions about this service

Can I install a tankless unit where a tank used to be?

Sometimes. A tankless unit needs a suitable vent, adequate gas or electrical capacity and enough flow. The old flue and the existing gas line often decide the answer before the unit does.

Does installation always need a permit?

In unincorporated Tuolumne County, new installation and replacement are permitted work. The county inspects strapping, combustion air, relief-valve piping, clearances and venting.

How do I know what size tank I need?

It depends on how many fixtures run at once and how the house is used. A seasonal cabin with two occupants and a rental sleeping eight need different answers, even in the same size of building.

Call(989) 601-2666