A tankless unit was the right answer for a lot of these cabins — no standing tank losing heat in an empty building, hot water on demand when people arrive. It also concentrates the local problems into a smaller box.
Freeze protection runs on electricity
The unit's internal freeze cycle needs power. A building shut off at the main for the winter gives the exchanger no protection, and water left in it can freeze and split the passages.
If the cabin is shut down, the unit is drained following the manufacturer's procedure — including the inlet filter and any internal drain plugs. That routine, done properly, is what keeps a tankless unit alive through a Sierra winter.
Scale, from a private well
Hardness plates the heat exchanger. The symptom is gradual: the same setting delivers cooler water, the unit runs longer, and eventually a code appears.
Descaling with a pump kit and a manufacturer-approved solution restores most of it. What descaling cannot fix is a passage already scaled solid or cracked.
Flow
Tankless units need a minimum flow to fire. A well pump that delivers weakly, a filter that has loaded up, or a single low-flow tap can sit under that threshold, and the result is short cycling or no hot water at all.
Flow is measured at the tap and compared with the unit's activation rate before anything is replaced.
Combustion and venting
The intake and exhaust terminations have to be clear of snow and clear of each other. A recirculation of exhaust into the intake produces ignition faults that look like a board failure.
Condensate
A condensing unit drains acidic condensate. In a freezing building that line freezes and the unit locks out. It is insulated, sloped and where necessary traced, and it is the first thing checked on a winter lockout.
Worth repairing?
A heat exchanger is the expensive part, and a cracked one usually ends the unit's life. Valves, flow sensors, igniters, boards and fan assemblies are all replaceable, and those are most of what actually fails.