Tankless units are common in newer construction on this corridor, and their failures are almost always one of four things: scale, flow, freezing or venting. The display code tells you which.
Scale in the exchanger
A tankless exchanger packs a large surface area into a small path. Hard water plates that surface, and the first symptom is not a failure — it is water that is no longer as hot at the same setting, or a unit that limits its own output.
Descaling with a pump and a suitable solution restores it. Skipping it long enough ends the exchanger instead.
Flow and temperature rise
These units heat on demand, so the flow rate and the temperature rise are tied together. Groundwater here is cold for much of the year, and a unit that satisfied a summer shower can struggle in January at the same flow.
Below the unit's minimum flow the burner shuts off rather than modulating down. A low-flow head or a partly closed valve can sit under that threshold, which reads as an intermittent fault.
Freeze protection
Tankless freeze protection is an active cycle, and it needs power. An empty building with the breaker off in February has none. A frozen exchanger cracks, and the leak appears when the building is opened again.
That is a building-management problem as much as an appliance one, and it is worth deciding in autumn rather than in spring.
Venting and condensate
Condensing units produce acidic condensate that must drain properly — a drain line that freezes is a fault, not a nuisance. The vent termination has to stay above the snow line on a roof that holds a season's accumulation.
Propane capacity
A tankless unit draws far more gas at once than a storage tank. On a propane system, an undersized line or a regulator that cannot hold pressure under that draw produces ignition faults and temperature complaints that look like control-board failures.
Before the diagnosis
Model, code, fuel, water source, and whether the building has been unheated. Four answers that decide most of the visit.