Tankless works well for buildings used in bursts, which is why a bathhouse or a bunkhouse here often has two or more units in a bank rather than one large tank. It also concentrates the failure modes into places a seasonal building tests hardest.
The bank and its behaviour
Units linked together stage on as demand rises. When one locks out, the rest still heat — at reduced capacity — so the first symptom is usually a complaint about the shower at the far end, not a total loss.
Reading the codes on each unit in the bank, rather than on the one nearest the door, is where the diagnosis starts.
Flow thresholds
Every tankless unit needs a minimum flow to fire. In a building with low-flow heads, a loaded inlet filter or a long run from a shared pump, a single fixture can sit below that threshold and produce nothing but cold water.
Flow at the outlet is measured against the unit's activation rate. That figure decides whether the fault is the unit or the plumbing.
Scale
On this water, hardness plates the exchangers. The signs are gradual: the same setting delivers cooler water, the units run longer, and a descale is overdue.
Descaling is a pump kit and the manufacturer's solution, and on a bank it is done unit by unit.
Freeze, condensate and the closed season
Freeze protection needs power. A building shut off for the winter leaves water in the exchangers, and a hard freeze can crack them — the one failure that ends a tankless unit's life.
The condensate line is the other winter fault in a condensing unit: it freezes, the unit locks out, and the fix is insulation, slope and heat on the line.
Venting
Intake and exhaust clearances matter more when several units sit close together. Recirculated exhaust produces ignition faults that read like electronics failures.
Repair or replace
Boards, flow sensors, igniters, valves and fans are replaceable. A cracked exchanger is not economic, and on a bank the sensible move is to keep the remaining units and replace the failed one with a matching model while it is still made.