Electric units dominate the cabins that were wired for them, and their failures here are seasonal in a way gas units' failures are not. A cold building and a winter's idle time produce specific faults.
The dry-start failure
This is the one to know. The tank is drained for the closed season, the power is switched back on in spring before the supply is opened, and both elements fail in seconds.
The unit then looks normal — no leak, no noise, no heat. Testing the elements for continuity is the diagnosis, and replacing them is usually all that is needed if the tank itself is sound.
Moisture in the wiring
An unheated building condenses. Moisture in the element covers, the junction box or the thermostat pocket produces nuisance trips and, occasionally, a short.
A breaker that trips again after being reset gets investigated rather than reset a third time. On a building that has been closed, that investigation starts with the wiring and the connections, not the thermostat.
Scale on a well supply
Hard private water coats the lower element and the tank floor. Coated, the element runs hotter than it should, draws more current and fails earlier. That is why element life on this supply is measured in years, not decades.
Flushing the tank and checking the element on replacement are the two things that keep the interval reasonable.
Thermostats and the reset
A high-limit trip on the upper thermostat is a symptom. The reset button is not the fix; the reason it tripped — a failed thermostat, a dry tank, a sediment layer — is.
Voltage, not guesswork
A multimeter at the element tells you whether power is arriving and whether the element is intact. Replacing parts without that test is how a simple fault becomes an expensive one.
When it is the panel
An old cabin panel with a dedicated 240-volt circuit that has been wet may need the circuit corrected, not the heater. That is electrical work, and it is settled before a new unit is connected to it.