An electric heater in a damp Cow Creek building has an extra failure mode: water where it should never be. The electrical compartment, the element plate and the connections at the top are all exposed to the humidity of the space.
Look before you reset
A tripped breaker gets one investigation, not a series of resets. Open the element cover and look for rust, staining or standing water. A wet connection explains both the trip and the corrosion around it.
If water has reached the compartment, the unit stays off until it is assessed.
Elements and thermostats
Cold water throughout points at the element circuit; lukewarm water at part capacity points at one element or thermostat in a two-element tank; water that never recovers points at the lower element or the thermostat reading low.
A high-limit that has opened did so because the tank overheated — usually a thermostat stuck closed. The safety is a symptom.
Sediment and idle time
A seasonal tank lets sediment settle into a layer that a busy tank would have moved along. Under the lower element it insulates, overheats and eventually kills the element.
Flushing is the intervention, and after the melt is a sensible time to do it, when the building is being opened anyway.
Corroded connections
In a damp space, the terminal connections and the element gasket corrode. A loose or corroded connection heats up, which is a fire risk rather than a performance issue, and it is checked as part of the repair.
The verdict
Where the tank is sound and dry, the repair is a part and the fix may also involve keeping the space drier. Where the shell is pitted at the base, the honest answer is a replacement — sited better than the last one.