Electric heating in these buildings carries two local risks: an unheated structure that condenses through the winter, and a service that was sized when the property had fewer buildings.
The dry start
Draining a tank for the closed season is correct. Restoring power before the tank is full is what destroys the elements. Water in, air bled from a hot tap, then the breaker on — in that order, every spring.
The failure is quiet. No leak, no trip, no heat. A continuity test on each element settles it in a few minutes.
Damp and the connections
An empty building gets cold, and cold surfaces collect moisture. Element covers, junction boxes and thermostat pockets are where it lands. A trip that recurs after a reset is investigated at those points before the thermostat is blamed.
Where a connection has been wet and heated, the fix is the connection — not a larger breaker.
Load on a shared service
A property that adds a unit, or replaces an old one with a larger element, changes the load on a service that may already be near its limit. Nuisance trips when the bathhouse and the kitchen run together are the symptom.
A load calculation before equipment is ordered prevents the argument afterwards.
Scale and element life
Private well water coats the lower element and the tank floor. Coated, an element runs hotter and draws more current, and its life shortens. Flushing and an occasional element change are the maintenance that keeps it reasonable.
Wiring
Old cabins often have a 240-volt circuit run in a way that predates current practice — no disconnect at the unit, no ground, a junction in a damp crawlspace. When a heater is replaced, that circuit is corrected, because a new unit on bad wiring is a call waiting to happen.
When it is the panel
A service that cannot support the load is an electrical job before it is a plumbing one, and it is resolved before the new unit is connected.