Dardanelle's gas water heaters run on propane, and propane at 5,774 feet in an unheated building is a supply question as much as an appliance question.
Pilot and ignition
A standing pilot that will not hold points at the thermocouple, the pilot orifice or the gas supply. A spark-ignition unit that clicks and locks out has not proved flame — igniter, sensor, valve, or venting.
One relight, following the label, is reasonable at the start of a season. A second attempt on a unit without knowing why it failed is not.
The vent in a snow year
A flue that ends near the roof surface is buried for the part of the year that matters most. The result inside is spillage at the draft hood, a yellow flame, soot, or a pilot that will not stay lit — and the real risk is carbon monoxide.
A CO alarm means leaving the building and calling the utility and 911. After that, the vent is fixed before the heater runs again.
Combustion air
A small mechanical space with a solid door and no opening starves a gas burner. It is also what a county inspection checks for, so it tends to be corrected at installation or replacement — and neglected in between.
Propane in cold weather
A tank that is low, a regulator that cannot hold pressure under load, or a line sized for a smaller appliance all produce the same complaint: it runs, then it quits. The appliance is often blamed for a supply problem.
What the visit establishes
Gas pressure at the unit, the pilot assembly and thermocouple, burner condition and air shutter, the flue and its termination, the combustion air path, the relief valve and the pan. In that order, because the pressure and vent findings change what the rest means.