Maintenance on a property like this is a calendar item, not a repair. Done in the fortnight before the buildings fill, it converts most first-week failures into corrections made while the place was empty.
The pre-season list
Water in the pan and at the base of each unit. The flue, for nests, loose caps and snow. The relief discharge pipe, clear and unpiped-into anywhere it should not be. Gas connections and manifold pressure. Controls exercised, pilot or ignition proved. Tanks flushed until the drain runs clear.
Each item is quick. Skipping one is how a building opens with a fault nobody can attend to until the weekend.
The draw test
Fill a bathhouse's worth of hot water demand at the far fixture and watch what happens: temperature holds, sags, or collapses. That single test tells you whether recovery matches the peak, which is the thing a group building actually fails at.
It also finds a recirculation fault — hot water that takes minutes to arrive at the end of a long run — before a guest does.
Anodes across several units
A property with six heaters has six anodes at six different stages. Checking the oldest or the hardest-worked one tells you what the rest need, and it is cheaper than pulling all six the same year.
On this water, the rod is the part that decides tank life.
Scale and descaling
Storage tanks get flushed. Tankless exchangers get descaled with a pump kit and the manufacturer's solution, and the interval follows the hardness rather than a printed figure.
Recording it
A one-page log per building — date, drain condition, anode, any water in the pan, draw-test result. Two seasons of that tells you which unit is going and lets the replacement be planned instead of absorbed.