A water event on a property with people in it is measured in minutes. The first job is not repair; it is stopping the water and keeping anyone from standing in it.
The first moves
Close the cold inlet at the failed unit. If water keeps coming, close the property main. Cut power at the breaker, or shut the gas control off.
Two rules hold in every case: nobody works on electrical equipment in standing water, and nobody goes looking for a gas source indoors.
Failure in one of several units
Where the building has more than one heater, isolating the failed one is the fastest route back to partial service. The remaining units then carry a reduced load, and the question of whether that is enough is answered by occupancy — how many people, for how long, and what the building needs to deliver.
Water above a ceiling
A tank on an upper floor puts water into the structure below. Shutting the branch valve, opening the ceiling where it is wet, and getting air through the space all happen before the replacement is discussed.
Gas
A smell of gas or a sounding CO alarm empties the building. Then the gas utility and 911. With a propane tank on the property, the tank's shut-off belongs to the supplier's procedure, not to an occupant with a wrench.
What the road allows
Highway 108 is plowed through the corridor except when a closure is in place; the private drive is the owner's arrangement. In February, access can be the deciding factor, and the honest answer is sometimes that the shut-down and the drying are the whole of tonight's work.
Afterwards
The failed unit is drained and removed, the pan and base are corrected, and the drive is checked before the replacement is loaded. The repair that follows an emergency should also remove the cause of it.