Skip to content
Rules & safetyBy Water Heater Repair Strawberry, CA

A leaking water heater: shut it off, read the leak, then call

What to do in the first ten minutes of a water heater leak, how the location of the water tells you what failed, and which leaks can be repaired.

Most of the damage in a water heater leak happens in the first half hour, and almost all of it is avoidable. The response is short: stop the water, take the energy off, then work out what failed.

The first ten minutes

Close the valve on the cold line feeding the heater. If the flow does not stop, close the property's main valve. Then cut the power at the breaker, or shut the gas control off.

Water and electricity do not share a space. If water has reached a panel, an outlet or the electrical compartment of the unit, stay out of the standing water and cut power at the main before anything else.

Read the leak before you clean up

Where the water appears is the diagnosis.

At the top connections: a union, a nipple or a flex connector. The most common and the most repairable.

At the relief valve or its discharge pipe: the valve is opening, which means pressure, temperature or a failed valve. A dripping discharge is a symptom to investigate, not just a part to swap.

At the base of the tank: either a leak running down from above, or a shell that has failed. The first is cheap, the second ends the unit.

At the drain valve: a valve that does not seat, or sediment holding it open.

Under a tankless unit: condensate, a connection, or a cracked exchanger. The last is not repairable.

The full breakdown of repairable and not is what water heater leak repair is built around.

What not to do

Do not tape, clamp or seal a pressurised tank and leave it. Do not relight a gas unit whose burner compartment has been wet. Do not run a unit with the relief valve plugged to stop the drip. That valve is the last protection against a tank turning into a pressure vessel.

After the water is off

Get air through the space. Wet insulation, wet framing and a damp crawlspace produce problems that outlast the repair, and the smell that follows is usually mould rather than the heater.

If the water reached drywall or a ceiling, opening it up to dry is faster and cheaper than waiting for the stain.

When it is an emergency

A tank that has split is an emergency: tens of gallons can leave in minutes. A slow drip caught in a pan is not, provided the pan drains and the supply can be shut. What makes the difference on this corridor is that the shut-off actually turns — a seized valve turns a small leak into a large one.

That is worth checking on a calm afternoon, before you need it.

The call

With the water off and the energy isolated, the useful information for a plumber is where the water appeared, whether the tank is holding pressure, and the age and fuel of the unit. With those three, the visit can be planned — and on a back road, planned properly — rather than guessed at.

Get in touch

Leak still running?

Shut the inlet and isolate the energy first, then call. Where the water showed up tells us more than how much of it there is.

Questions about this article

What do I shut off first?

The cold inlet valve on the heater. If the water keeps coming, the property main. Then the power at the breaker, or the gas control to off.

Does the water ever lie about where the leak is?

Often. Water runs along pipes and joists, so a fitting at the top can surface as a puddle at the base. Trace upward before assuming the tank.

Can a tank leak be sealed?

Not the shell. A seam or a pinhole in the steel is the end of the unit; fittings, valves, gaskets and element seals are repairs.

Call(989) 601-2666